Nilox 17NXGCON38001, Руководство пользователя

Страница: 28 / 57

Battery mode start (Cold Start)

Hold down the UPS ON button for about 3 seconds to turn on the unit. The buzzer will beep twice. Release
the ON button and repeat the procedure within 10 seconds, holding down the ON button again at UPS start for
about 3 seconds. If the procedure was correctly followed, the UPS will start in Cold Start mode and the LCD
display will show the image illustrated below. The UPS is operating in Backup mode [buzzer, indicator
on].
UPS
Battery
V
LOAD INPUT

The following limits must be met in Cold Start mode:

The load should not exceed 80% of the supported load

The load should remain constant
Information found on the display
Values and messages can be viewed by pressing key (when the UPS is running in Normal/Battery mode). The
following is displayed in order: AC Input Voltage, AC Input Frequency, UPS Output Voltage, UPS Output Frequency,
UPS Load %, UPS Output Current, UPS Battery Voltage.
UPS
V
LOAD INPUT UPS LOAD INPUT
Hz
UPS LOAD INPUT
V
UPS
LOAD INPUT
Hz
UPS LOAD INPUT
%
UPS LOAD INPUT
A
UPS LOAD INPUT
V
Battery
UPS block
The UPS can block following particular events. A screen will appear on the LCD display with numeric information
on the block code.
UPS LOAD INPUT
Code
The following procedure unlocks the device.

Note the displayed error code (contact customer service for information on problem solving).

Press the OFF button and hold down for 5 seconds until the device beeps twice.

Remove the power cord.

Wait until the UPS is fully off. The UPS is fully unlocked at this point.