7
Operating
instructions
EN
3.2 Starting-up
procedure
Check oil
Turn the thermostat to the BLUE fi eld.
Turn to position
“START”
.
Check that the oil in the oil reservoir (2) is between the MIN and the MAX markings. Oil type: Nilfi sk-ALTO
Pump Oil 100.
Check the oil level on the Honda engine (5). Oil type: Choose oil type in accordance with the instructions in
the Honda manual.
Open the petrol cock (pos. 19) by pulling the control knob out. Activate the choke (pos. 20) if necessary by
pulling the control knob out.
Turn the temperature control (16) to the BLUE fi eld. Make sure that the high pres sure hose has been cor-
rect ly mounted.
Start the Honda engine as described in the enclosed operating instructions.
The key for the electric start has the following three positions:
1:
“
O
” off
2:
“
I
” run
3: “Start” - the key will return to position 2 when released
Gradually push in the choke control if having been used.
3.3 Operation
Always hold the spray lance with both
hands!
Always lock the spray handle when the
cleaner is not in operation.
Activate the high pressure washer by releasing the trigger of the spray handle (28). When starting up the
machine the pressure may be unsteady because of air in the pump system. After a short time the air will
escape from the system and the pressure will become steady.
When the engine has been warmed up, check that the max. working pressure does NOT exceed the max-
i mum allowable pump pressure (see section "1.2 Technical data"). This can be taken from the pres sure
gauge (pos. 21).
Do not let the machine run for more than 5 minutes once the spray handle has been released
(the
pump then circulates the water internally and the machine will overheat unless stopped after 5 min utes).
When the cleaner is not in use, secure the spray handle by turning the safety knob (33) into pos.
0
.
150
130
110
90
70
50
˚C
300
265
230
195
160
125
˚F
TEMP
˚C
140
130
110
90
150
120
100
80
70
50 60
40
30
16
19
18
20
33
28