WARNING!
Modifications or alterations to this machine can lead
to personal injury or damage to the machine.
DO
NOT
make
unauthorized modifications or alterations to this machine.
Nilfisk-Advance assumes no liabilities for injury or damage
resulting from an unauthorized modification or alteration to the
machine. Any unauthorized modification or alteration to this
machine voids all warranties.
WARNING!
The muffler and the engine become hot enough
while the machine is in operation, and for a long time after the
machine is shut off, to cause severe burns.
DO NOT
touch
these parts of the machine until they have cooled.
WARNING!
Injury can occur to the eyes and body while using
the machine. Safety goggles, safety shoes, and safety
clothing are recommended while operating the machine.
WARNING!
Continuous exposure to high noise levels can cause
hearing loss. Hearing protection is recommended while the
machine is in operation.
WARNING!
Machine vibration may cause tingling or numbness
in the fingers or hands. Gloves are recommended to reduce
machine vibration. If tingling or numbness persists, shut off
the machine. If the vibration is caused by loose parts, adjust
or tighten these parts before using the machine again.
CAUTION!
A dirty engine filter can cause overheating. Check
and replace following recommended maintenance schedule.
CAUTION!
Overheating can be caused by insufficient or low oil.
Check oil before each use, and fill or change as needed.
CAUTION!
Never over-fill engine with oil. Over-filling could
cause irreparable damage to the engine.
CAUTION!
Overheating can be caused by dirty oil. Check oil
before each use and change regularly following recommended
maintenance schedule.
CAUTION!
Do not engage starter for more than 5 seconds.
Allow a 10 second cool-down period for second failed start-up
attempt.
CAUTION!
Perform all recommended scheduled maintenance.
Regular maintenance of your propane powered floor machine
is necessary to keep it in safe working condition.
CAUTION! DO NOT
operate machine unless trained and
authorized.
DO NOT
operate machine unless you have read
and understand the operation manual.
DO NOT
operate
machine in flammable or explosive areas.
CAUTION!
Before starting machine ensure all safety devices
are in place and functioning properly. Before starting machine
check for proper operation.
CAUTION!
When using machine, go slowly on inclines or
slippery surfaces. Use care when operating machine in
reverse.
CAUTION!
When servicing machine, stay clear of moving parts.
DO NOT
wear loose clothing when working on machine. Block
machine wheels before raising or jacking up machine. Use
hoist stands that will support the weight of the machine. Wear
eye and ear protection when using pressurized air or water.
Disconnect battery connections before servicing machine. Use
only replacement parts supplied by Nilfisk-Advance or a Nilfisk-
Advance Authorized Distributor or Service Center.
CAUTION!
When loading or unloading machine onto or off a
truck or trailer, turn machine OFF. Only use a truck or trailer
that will support the weight of the machine to transport.
DO
NOT
push the machine onto or off a truck or trailer unless the
load height is 15 in (380mm) or less from the ground. Block
machine wheels when transporting. Tie the machine down
securely to truck or trailer when transporting.
A8
Содержание PBU 56384165
