Nilfisk-Advance PBU 56384165, Руководство оператора

Страница: 13 / 80

A13
Pad Change
1. Close the valve on the propane cylinder, allow the
engine to stop and turn the machine OFF.
2. Remove the propane cylinder.
3. Raise the handle to the full-up position (about a 45°
angle).
4. Lift up on the front of the deck rocking the machine
back until it rests on the handle grips.
5. Remove centering device and inspect pad. If pad
has worn to less than a 1/4” (6mm) thick, replace it.
CAUTION! Carefully inspect the pad holder for cracks
or damage. Replace if necessary.
WARNING!
A damaged pad holder rotating at high
speeds may be an extreme hazard if it should come
apart.
6. When lowering the machine down, do not drop the
machine. Slowly lower the machine to the floor
until the wheels are on the ground.
Fuses
The machine’s electrical circuit is protected by a fuse,
which stops the flow of current in the event of a circuit
overload. Once a fuse blows, it must be replaced. If
the overload that caused the fuse to fail is still present,
the new fuse will fail and the problem must be corrected.
DO NOT
bypass any fuse. The ignition fuse is located
on the side of the starter switch panel.
Wheel Adjustment
1. Close the valve on the propane cylinder, allow the
engine to stop and turn the machine OFF.
2. Remove the propane cylinder.
3. Raise the handle to the full-up position (about a 45°
angle).
4. Rock the machine by lifting up on the front of the
machine until it rests on the handle grips.
5. Remove the bolt that retains each wheel and relocate
to the desired wheel position.
NOTE: To increase pad pressure (more aggressive)
move wheels to rear of machine. To decrease pad
pressure (less aggressive) move wheels toward the
front of machine.
Fuse