Niles iREMOTE TS, Быстрая установка

Страница: 21 / 32

19
www.nilesaudio.com
oPeRAtiNG tHe iRemotetS
Charging the iRemoteTS
The iremoteTS uses a lithium ion rechargeable battery and should
always be placed in the charging base when not in use. A full
charge will last approximately 24 –48 hours. When the battery
is low, the touch screen will display: “Battery Low, Please Place
in Charger.” When the iremoteTS is placed in the charging base,
an LED illuminates white to indicate that it is properly placed in
the base and the battery is charging. After the iremoteTS has
been fully charged the charging LED on the base will go out.
If the LED doesn’t light up, the remote has not been placed into
the base properly. If the LED illuminates red, there is a fault in
the battery and it should be replaced. Contact Niles Technical
Support for information on battery replacement.
The iremoteTS will go into a sleep mode when not in use. This
helps to conserve the battery. Picking up the iremoteTS or pressing
any hard button will wake up the iremoteTS. This sleep mode is
configurable in the iremote System Settings menu.
When leaving the iRemoteTS unused for long period of time (such
as when used in a vacation home) it is best to leave the iRemoteTS
in its charging base and the charging base plugged in.
Selecting Theater or House Control
once awake, press the house button to control the multiZone
system, or the Theater button to control the home theater. When
the Theater button is pressed, you can see up to 12 master Keys,
each labeled for home theater sources or activities. The number
of master Keys seen is dictated by the configuration programmed
by IntelliFile 3.
When the house button is pressed, the iremoteTS shows the
status of the zone of the iremoteTS that was last left on. To select
a different zone, press the Niles logo button. A list of available
zones will be shown. Select a new zone by pressing the zone
name on the touch screen. If the newly selected zone is turned
off, the IntelliControl ICS splash screen will be displayed with the
labeled master Keys across the top. If the newly selected zone
is already on, the currently selected source for that zone will be
displayed.