NIKKARI SSET, Инструкция по эксплуатации, Страница: 21 / 40

21
4.2 Pre-operation Check
Make sure that the edger is operated normally or there is not any part missing
or damaged before starting the operation.
Before operating the edger, check the following.
(a) If any part is damaged or worn out, replace before using. Contact your service dealer for a
replacement part.
● Check to see if there is any looseness, cracks, bending, or distortion of parts (nuts, screws, etc.)
● Check to see if the blade is damaged.
● Check to see if the knob bolt of powerhead connections is loosened.
(b) Check to see if the edger functions normally. If it is faulty, contact your servicing dealer for repair.
● Check to see if the throttle trigger is operating freely (if it returns to the idling position).
● Check to see if the start/stop switch functions normally.
(c) Check the handle for dirt, etc. If it is dirty, wipe it off.
● Check to see if it is kept clean (if there is oil or resin adhering.)
● Be sure it’s dry before using.
(d) Check the idling status. If it is faulty, perform the steps described in the powerhead manual.
● Check to see if the blade moves during idling.
If it does, stop the engine and contact the servicing dealer for repair.
(e) Tighten the mounting bolts of the blade.
If there is any looseness, it could result in serious injury.
For tightening the bolts of blade, refer to “3.2 Installation and Removal of Blade”.
(f) Check the blade.
Make sure that there is no break, chip-off, bending, burr, crack, etc.
(g) Make sure that the wheel rotates smoothly.
If there is any abnormality, clean the wheel according to "5.3.2 Cleaning of wheel”.
(h) In addition to the above, perform the steps described in the powerhead manual.