Nidek Medical LEX-DRILL, Руководство по обслуживанию

Страница: 63 / 94

LHM2A*RDA001A/E
7 - 21
2. Check the holes 1 to 7 to find one which indicates that the drill bit is inserted at a proper
angle.
Hole A as shown in the figure below is optimum.
If there is no optimum hole due to off-line, increase or decrease the Drill tool angle parameter
by 1.2 as follows, and drill a lens again.
1) For Hole B as in the figure below, decrease the parameter by 1.2 .
2) For Hole C as in the figure below, increase the parameter by 1.2.
3) If hole 6 is optimum, increase the parameter by 0.4.
3. Adjust the Drill tool angle parameter with the
compensation value according to each hole.
[Lex 1000]
1) Press while pressing to display
the Parameter screen.
2) Press to select “Parameter Setting”,
then press .
3) Press “Prev page” or “Next page” to display
“Drill Parameter 13/15”.
4) Press to highlight “Drill tool angle” and
change the set value with or .
5) Seeing the table to the right, change the
set value according to the hole No.
* For example: When hole 6 is optimum,
increase the parameter by 0.4.
Hole No. Compensation value
Ԟ
ԝ
Ԝ
ԛ
Ԛ
ԙ
Ԙ
Lens front surface
(Lens center side)
(Lens edge side)