4 - MAINTENANCE
SPDM CONTROL BOX
NIDEC ASI S.P.A. – SPDM CONTROL BOX USER MANUAL
48
IMSPDCB2EN
Saving drive parameter values
The
Next
and
Finish
button are initially disabled. You have to
provide the correct drive IP address in the
IP Address
text box. To
start the save process just click on the
Save Parameter Values
button.
Fig. 4.4-4 - Saving drive parameter values. Type IP address
The ongoing process is notified by a progress bar and a messages
output area. You have to wait a few seconds for the process to
complete.
T
he procedure will try to save parameter values
based on the configuration provided by the modules you have
selected to install. Maybe some parameter does not exist in the pre-
existing Drive configuration and a read error will be logged. This is
usually not an error.
Fig. 4.4-5 - Saving drive parameter values. Ongoing process
When the process finish, you will be able to read the operation log in
the message output area.
You can click on the
OK
button to continue the procedure.
Fig. 4.4-6 - Saving Drive parameter values. Operation Done
Downloading the Firmware
In this step you will be asked to download the firmware. This is a
“no
rollback”
process so you have to do it only if you are sure of what
you are doing. If you previously saved the parameter values the
IP
address field should be already filled with the correct ip address,
otherwise please type in the correct ip. You can test if that ip
address is reachable by clicking on the
Test
button.
The fields
User
and
Password
are already filled with the correct
values. Leave them as they are.
Initially
Next
and
Finish
button are disabled. You have to click on
the red
Download Firmware!
button to proceed.
Fig. 4.4-7 - Download Firmware. OK to start
NOTE
