Nicotra Gebhardt 6RA0005ZZ0000000, Руководство по эксплуатации

Страница: 50 / 52

Rev. 0 - 05/11/2020
OPERATING MANUAL OPERATING MANUAL
EN EN
50/52
The system status can be displayed through the LED on the driver plate (see par. 9.6).
In the following figure on the right the blinking LED is shown.
18.3 Blinking LED - Alarm description
18. ALARM HANDLING
When a malfunctioning occurs, the driver has two possible behaviors depending on the cause of the alarm:
BLOCKING
The cause of the alarm is very dangerous -> The driver stops immediately. To restart the fan, once the
problem has been corrected, it is necessary to reset the fan or power the driver off for 5 minutes.
AUTO-RESTARTING
The cause of the alarm is contingent to a wrong setting or wrong working condition. The alarm indica -
tions are activated, but after some seconds the fan tries to restart automatically.
The alarms can be monitored through three different ways:
• Modbus Registers
• Blinking LED
• Digital Output
18.1 Monitoring
In the following table, the alarms and the values stored in the related Modbus Input Register 10 and Input Register 17 are indicated.
18.2 Modbus registers - Alarm description
Alarm 1 Alarm 2 Description Actions Type
0 0 Default operation – No Errors No Actions ALARM 1
1 0 Memory error Blocking condition ALARM 2
2 0
Short Circuit Blocking condition ALARM 3
3 0
Loss of synchronism Auto-restarting condition ALARM 4
4 1
Input Voltage outside range (only with motor stopped) Auto-restarting condition ALARM 4
4 32 BUS overvoltage (instantaneous measurement) Auto-restarting condition ALARM 4
4 33 BUS undervoltage (instantaneous measurement) Auto-restarting condition ALARM 4
4 34 Input relay not closed Auto-restarting condition ALARM 4
4 49 Missing phase – U cable disconnected Blocking condition ALARM 4
4 50
Missing phase – V cable disconnected Blocking condition ALARM 4
4 51
Missing phase – W cable disconnected Blocking condition ALARM 4
4 52 High starting current Auto-restarting condition ALARM 4
4 113 Overtemperature Auto-restarting condition ALARM 4
4 255 Loss of communication Blocking condition ALARM 4
The Driver is NOT protected against a very high-power supply voltage.
A very low power supply voltage during the motor running could damage Driver.
WARNING WARNING
1 sec.