LIT-218
NICO
Corporation
Rev. C
(English)
Page 11 of 22
6.2.1.1 ENGAGE LAMP
(Refer to
8.1 LAMP REPLACEMENT
) Disconnect power. Open the door. The lamp
positioning lever should be completely down(horizontal) to properly engage the lamp
and completely up (vertical) to release it. Raise the lever completely if not already
raised and firmly push the lamp to assure full engagement to the power connectors.
Lower the lamp engagement lever counter-clockwise, from vertical to horizontal, and
observe that the lamp rises slightly as it is engaged into proper operating position.
6.2.1.2 CLOSE DOOR
Close the door completely. (Fan will continue to run with door open.)
6.2.1.3
INCOMPATIBLE LAMP MODULE INSTALLED
Install correct STX0350 lamp.
The digital control system communicates with Sunoptic Technologies
®
lamps
designed for it. Only Sunoptic Technologies
®
lamps can be engaged by the
positioning mechanism.
