NC-AD300E Manual
- 39 -
"WaitDelay" is used to set the timeout to receive the button, if more than this time no button
pressed, will stop waitting.
"WaitLength", if set to "unknown", according to the definition in "Process using” to deal with;
otherwise, according to the selection length to do treatment; proposals set to "unknown".
"End Key" to specify which key to press is the end of numbers, usually set to "#."
"LoopTimes" designated number of times the playback voice prompts. If more than this number,
still no button pressed, then the call will be terminated.
“PromptVocIndex” designate the welcome prompt tune, main instruction tune and fail prompt tune
voice index.if you fill out”0”.use the default voice.
“Process using” designates the follow up call process after the selection key pressed
Tips:More than one route can be configured out of a simple nested
multi-level menus Process
。
。
。
。
1)Secondary
1)Secondary
1)Secondary
1)Secondary Dial-up
Dial-up
Dial-up
Dial-up
play dial tone to prompt the user to re-dial.It is the same to the “turn computer operator”
function, the only problem is that it playdial tone only one time,while “turn computer operator”
can play back recorded voice. Routing content to set operational definitions, as follows:
