13
GB
Pause Time
Funzione P.P.
Motor speed
FLASH
output.ì
Motor Force
on opening
Motor Force
on closing
L1
L2
L3
L4
L5
L6
L7
L8
L1
L2
L3
L4
L5
L6
L7
L8
L1
L2
L3
L4
L5
L6
L7
L8
L1
L2
L3
L4
L5
L6
L7
L8
L1
L2
L3
L4
L5
L6
L7
L8
L1
L2
L3
L4
L5
L6
L7
L8
10 seconds
20 seconds
40 seconds
60 seconds
80 seconds
120 seconds
160 seconds
200 seconds
Open - stop - close - stop
Open - stop - close- open
Open - close - open - close
Apartment block
Apartment block 2 (more than 2” generates stop)
Step-step 2 (less than 2” generates partial open)
Hold-to-run
Opening in “semiautomatic”, closure in “hold-to-run””
Speed 1 (30% - slow)
Speed 2 (44%)
Speed 3 (58%)
Speed 4 (72%)
Speed 5 (86%)
Speed 6 (100% - fast)
Open V4, close V2
Open V6, close V4
Door Open Indicator
Active if door closed
Active if door open
Flashing light
Electric block
Electric lock
Suction cup
Maintenance indicator
Force 1 (low)
Force 2
Force 3
Force 4
Force 5
Force 6
Force 7
Force8 (high)
Force 1 (low)
Force 2
Force 3
Force 4
Force 5
Force 6
Force 7
Force8 (high)
10.3) Level 2 Functions (settable parameters)
Table 4: list of programmable functions: level 2
Input Led
Parameter
Led (level)
Value
Description
Sets the pause time, i.e. the
time before automatic
closure. Applied only when
auto-matic closure function
is enabled
Sets the sequence of
commands associated with
the SS input or the 1st
radio command.
Sets the motor speed
during normal travel.
Selects the device
connected to the FLASH
output.
Sets the system for
controlling motor force, to
adapt it to the weight of the
door during the opening
manoeuvre.
Sets the system for
controlling motor force, to
adapt it to the weight of the
door during the closing
manoeuvre.
Note: “
“ represents factory settings
SEGUE
L1
L2
L3
L4
L5
L6
10.2) Level 1 programming
By default level 1 function are all set to OFF, but can be modified at any time as described below. Take care during modification procedures,
as there is a maximum time interval of 10 seconds between pressing one key and another; otherwise the system exits the procedure auto-
matically memorising the changes made up to that time.
Wait 10s to exit the programming mode automatically after the maximum time interval.
Note:
points 3 and 4 can be repeated during the same program-ming phase to set other functions to ON or OFF.
1.
Press and hold
[Set]
for approx. 3s
2.
Release
[Set]
when led L1 starts flashing.
3.
Press keys
[
▲
]
or
[
▼
]
to move the flashing led to the led associated with the function to be modified
4.
Press
[Set]
to change the status of the function (short flash = OFF; long flash = ON)
