Nice S-BAR, Инструкции и предупреждения по установке и использованию

Страница: 15 / 93

Led 8 Description
Off During normal operation it indicates that Pole closing is set to the left.
On During normal operation it indicates that Pole closing is set to the right
Flashes Programming of functions in progress.
EN
14 – English
TABLE 16
Signal Cause Solution
8.4.2 - Flashing light signals
If a flashing light is connected to the FLASH output on the control unit (or the
edge light if the LED flashing light XBA7 is connected, optional accessory), this
emits flashes at intervals of 1 second during execution of a manoeuvre. If faults
occur, the flashing light will emit shorter flashes; these are repeated twice, sep-
arated by a 1 second pause. The same signals are also emitted by the courtesy
light and the “Bluebus” led.
Table 16 shows the cause and solution for each
type of signal.
1 flash
second pause
1 flash Bluebus system error At the start of the manoeuvre, the devices connected to Bluebus
do not correspond to those recognized during the self-learning
phase. One or more devices may be faulty; check and, if necessa-
ry, replace them. In case of modifications repeat the device self-
learning process (see paragraph 4.5).
2 flashes
second pause
2 flashes Photocell activated At the start of the manoeuvre, one or more photocells do not ena-
ble it; check to see if there are any obstacles.
3 flashes
second pause
3 flashes Activation of Motor Force limiter During the movement, the pole has experienced excessive fric-
tion; identify the cause.
6 flashes
second pause
6 flashes Maximum limit of manoeuvres per hour exceeded Wait a few minutes until the manoeuvre limiting device falls to
below the maximum limit.
7 flashes
second pause
7 flashes Error in internal electric circuits Disconnect all power circuits for a few seconds and then retry a
command; if the condition persists this may indicate a serious fault
with the board or motor wiring. Check and make replacements as
necessary.
8 flashes
second pause
8 flashes – Reserved for Nice Technical Assistance
9 flashes
second pause
9 flashes Block automation Send the command “Release automation” or control the manoeu-
vre with “High Priority Step Step”.
4 flashes
second pause
4 flashes STOP input activation At the start of the manoeuvre or during the movement, the STOP
input was activated; identify the cause.
5 flashes
second pause
5 flashes Error on internal parameters in control unit Wait at least 30 seconds, then try giving a command. If the condi-
tion persists, there may be a serious malfunction and the electro-
nic board must be replaced.