Nice ROBUS350, Руководство по установке

Страница: 20 / 136

Irradiated power
Dimensions and weight
From 100 to 150 m. The range can vary if there are obstacles or electromagnetic disturbances, and is
affected by the position of the receiving aerial
Use in acid, saline or potentially explosive
atmosphere
330 x 195 h 227; 8Kg
Nice S.p.a., in order to improve its products, reserves the right to modify their technical characteristics at any time without prior notice. In
any case, the manufacturer guarantees their functionality and fitness for the intended purposes.
All the technical characteristics refer to a room temperature of 20°C (±5°C).
8) Technical characteristics
Type
Technical characteristics: ROBUS350
Electromechanical gearmotor for the automatic movement of sliding gates for residential
use, complete with electronic control unit.
Pinion Z: 15; Module: 4; Pitch: 12,6mm; Pitch diameter: 60mm
Peak thrust
18Nm; corresponds to the ability to start a leaf with a static friction of max. 600N
moving.
Nominal torque
10Nm; corresponds to the ability to keep a leaf with a dynamic friction max. 333N
moving.
Nominal torque speed
0,18m/s
Idling speed
0,34m/s
Maximum frequency of operating cycles 50 cycles per day (the control unit allows up to the maximum described in tables 1 and 2)
Maximum continuous operating time
10 minutes (the control unit limits the continuous operation up to the maximum descri-
bed in tables 1 and 2)
Operating limits
In general, ROBUS350 is suitable for the automation of gates featuring leaves up to 15 m
wide and weighing up to 350 kg, as shown in Tables 1 and 2.
Max. absorbed power 250VA
Insulation class 1 (a safety grounding system is required)
Emergency power supply With PS124 optional accessory
Flashing Light Output For 1 LUCYE flashing light (12V, 21 W lamp)
BLUEBUS Output One output with a maximum load of 15 BlueBus units
STOP Input
For normally open contacts, for 8.2K
Ω
constant resistance, or normally closed contacts; with
self-recognition (any variation from the memorized status causes the “STOP” command)
Step-by-step Input For normally open contacts (the closing of the contact causes the “STEP-BY-STEP” command)
Radio AERIAL Input 52 Ω for RG58 or similar type of cable
ROBUS350 Power supply
ROBUS350/V1 Power supply 230Vac (+10% +15%) 50/60Hz.
120Vac (+10% +15%) 50/60Hz.
Programmable functions 6 ON-OFF functions and 6 adjustable functions (see tables 12 and 14)
Operating temperature -20°C ÷ 50°C
No
Protection class IP 44
Dimensions and weight
Recognition functions
Recognition of the devices connected up to the BlueBUS output. Recognition of the type
of "STOP" device (Normally Open or Normally Closed contact or 8.2K
Ω resistance).
Recognition of the length of the gate and calculation of the slowdown and partial opening
points.
Outputs 4 (on SM connector)
Operating temperature -10°C ÷ 55°C
Type
Technical characteristics Radio receiver: SMXI Radio receiver: SMXIS
4 channel receiver for radio control devices.
Frequency 433.92MHz
Coding Digital Rolling code with 53 Bit code, FLOR type Digital Rolling code with 64 Bit code, SMILO type
Transmitter compatibility
FLOR, VERY VR; only single group: ERGO, PLA-
NO, PLANOTIME, SMILO
SMILO
Transmitters memorized Up to 256 if memorized in mode 1
Input impedance 52 Ω
Sensitivity better than 0.5µV
Range of the transmitters
72 x 40 h 18mm / 30g Diameter 48 h14mm / 19g
Protection class IP40 (suitable for use indoors or in protected environments)
Operating temperature -40°C ÷ 85°C
Type 2 channel transmitter for radio command
Frequency 433.92MHz
Coding Digital Rolling code with 53 Bit code, FLOR type Digital Rolling code with 64 Bit code, SMILO type
Buttons 2
Power supply 12Vdc with 23A battery
Absorption 25mA
Battery life
1 year, estimated on the basis of 10 commands/day, each lasting 1s at 20°C (at low temperatures the
efficiency of the batteries decreases)
100µW
Technical characteristics transmitter: FLO2R-S transmitter: SM2
20