Nice E MAT MT 1517, Инструкции по установке и использованию

Страница: 9 / 40

EN
English – 7
5
sec.
01
04
02
THE
END
05
5
sec.
03
2 2 4
5
sec.
5
sec.
“ 1 ”
3
Note – When performing the procedure, at any time you can cancel it by keeping the
n
and
t
keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
––––––––––
Note – After the adjustments, the
s
key will command the Raising motion and the key
t
key will command the Lowering motion. The awning will move within the
limits constituted by the two limit switch heights.
5.7 - Semiautomatic programming of the limit switches
WARNING! – This programming applies to awnings which have the box, thus with retainer in the Upper limit switch “0”. The
same procedure also applies when the retainer is in the Lower limit switch “1”.
Warnings:
– The first limit switch to be adjusted must be the one with the retainer against the structure : the procedure below is an example of programming for an
awning with a box.
– This procedure overwrites previously adjusted heights with the new heights using this same procedure.
– Memorising the limit switches with this procedure, the two heights are controlled and updated constantly by the “limit switch self-update” function (see paragraph
7.2).
– Every time the motor is powered, 2 movements are performed if at least one transmitter and the limit switch heights are not in the memory.
Before starting the procedure, bring the awning to the midpoint of its stroke.
01. Run the UP command by keeping the
s
(or
t
) key pressed and wait for the awning to stop automatically as result of the impact against the structure (= upper
limit switch “0”) . Upon completion, release the key.
02. Run the Down command by keeping the
s
(or
t
) key pressed and release the key when the awning is next to your chosen lower limit switch “1”.
03. Keep the
n
key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
04. Keep the
n
key pressed again and wait for the motor to perform 4 movements. Upon completion, release the key.
05. Keep the
t
key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
06. Fine adjustment of position : Press the
t
and
s
keys until the awning reaches the “1” height you want (at each pulse the awning moves a few millimetres).
07. Keep the
n
key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
“ 1 ”
01
5
sec.
03
06
THE
END
07
04
5
sec.
05
02
5
sec.
“ 0 ”
2 4 2
“
1
”
5
sec.
3
Note – When performing the procedure, at any time you can cancel it by keeping the
n
and
t
keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
––––––––––
Note – After this programming, the
s
key will command the Raise manoeuvre and the
t
key will command the Lower manoeuvre. During the Raising manoeuvre, the
awning will be stopped by the impact against the mechanical blocks of the structure (= upper limit switch “0”), while during the Lowering manoeuvre the awning will
stop at the lower limit switch (“1”) estabilished by the installer.
END
END