Nice E MAT MT 1517, Инструкции по установке и использованию

Страница: 8 / 40

EN
6 – English
5.5 - Memorising the FIRST transmitter
Warning – Every time the motor is powered, 2 movements are performed if at least one transmitter and the limit switch heights are not in the memory.
01. Disconnect the power supply to the motor; wait two seconds and reconnect the power supply: the motor performs 2 movements and waits with no time limit.
02. Keep the key
n
pressed and wait for the motor to perform three movements. Upon completion, release the key.
2
sec.
ON OFF
01 02
THE
END 5
sec.
2
3
––––––––––
Note – After memorisation, the raising and lowering direction of the awning is not yet associated with the
s
and
t
respective keys of the transmitter. This combina-
tion will occur automatically when adjusting limit switches “ 0 ” and “ 1 ”; moreover, the rolling shutter will move in the “operator present” mode until the limit switches
are adjusted.
PROCEDURES
5.6 - Manual adjustment of upper limit switch height (“0”) and lower height (“1”)
Warning
:
– This procedure overwrites previously adjusted heights with the new heights using this same procedure.
– Every time the motor is powered, 2 movements are performed if at least one transmitter and the limit switch heights are not in the memory.
5.6.1 - To adjust the UPPER limit switch (“0”)
Before starting the procedure, bring the awning to the midpoint of its stroke.
01. Keep the
n
key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02. Keep the
n
key pressed again and wait for the motor to perform 4 movements. Upon completion, release the key.
03. Keep the
s
key pressed and wait for the motor to perform two movements. Upon completion, release the key.
04. Adjustment of the position
: keep the
s
(or
t
) key pressed until the awning reaches the desired “0” height.
Note
– to adjust the height with precision, press
the
s
and
t
keys several times consecutively (at each pulse the awning moves a few millimetres).
05.
Keep the
n
key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
5
sec.
01
04
02
THE
END
05
5
sec.
03
5
sec.
2 2 4
“
0
”
5
sec.
3
Note
– When performing the procedure, at any time you can cancel it by keeping the
n
and
t
keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
5.6.2 - To adjust the LOWER limit switch (“1”)
Before starting the procedure, bring the awning to the midpoint of its stroke.
01.
Keep the
n
key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02.
Keep the
n
key pressed again and wait for the motor to perform 4 movements. Upon completion, release the key.
03.
Keep the
t
key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
04. Adjustment of the position
: Keep the
t
(or
s
) key pressed until the awning reaches the desired “1” height.
Note
– to adjust the height with precision, press
the
s
and
t
keys several times consecutively (at each pulse the awning moves a few millimetres).
05.
Keep the
n
key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
Adjustment of the limit switch heights and intermediate heights
END
END