Nibe VPB 200N, Руководство по установке

Страница: 15 / 28

NOTE
Electrical installation and service must be carried
out under the supervision of a qualified electri-
cian. Electrical installation and wiring must be
carried out in accordance with the stipulations
in force.
Sensors
VPB 200N can be supplemented with up to two hot water
sensors, one for display and one for control. The display
sensor is positioned in the submerged tube for the display
sensor (UA1) and the control sensor in the submerged
tube for control sensor (UA2). In cases where it is only
possible to connect one sensor, use the submerged tube
for control sensor (UA2).
NOTE
Use the supplied heat conducting paste when
positioning the sensor in the submerged tube
(UA2) and ensure that the sensor is in the sub-
merged tube fully and that the cover disc is
sealed.
The bulb for the temperature limiter is in the submerged
tube for the display sensor. Any sensors must be installed
above the bulb.
Use the sensors provided with the heat pump/control
module. When no heat sensors have been provided these
must be ordered from the manufacturer of the heat
pump/control module.
LEK
8$
8$
Install the temperature sensor using heat conducting
paste.
Temperature limiter
Electrical supply to the temperature limiter (FD1) is 230
V. Connect the temperature limiter as follows:
1. Connect the temperature limiter (FD1) electrical to
the magnetic shut off valve.
Immersion heater
Power supply to the immersion heater (EB1) is 230 V. The
immersion heater's thermostat must be set to 5 (68 °C).
13 Chapter 5 | Electrical installation VPB 200N
5 Electrical installation