Nibe DVC 10-50, Руководство пользователя

Страница: 9 / 36

www.nibe.com
9
3. Glue the supplied cardboard mounting template with a sealing tape on the indoor wall. Mate the large hole in the template with the air duct. Use
a builder’s level for horizontal alignment of the mounting template.
Mark the openings for dowels from the fastening kit and drill holes to a required depth. Route the power cable from the ventilator outside through
the marked opening on the mounting template.
4. Press the side tabs to detach the front part of the indoor unit from its back part.
Prior to mounting the front
panel make sure that the
thermal actuator rod is in
the lowest position and the
light indicator is at least two
minutes off.
5. Fix the back part of the indoor unit on the wall with the supplied screws. Remove the two screws from the left transparent cover to enable access
to the terminals.
6. Route the power cable as shown in the figure and connect the ventilator
to power supply in compliance with the wiring diagram. Fix the power
cable and the control cables with the cable clamp. After connection re-
install the transparent cover.
Cable clamp Cable clamp