PARTS:
• • 2 x T-Nuts
PARTS:
• • 2 x M8 16mm Bolts
• • 2 x M8 Nylon Washers
• • Tool Kit Holder
PARTS:
• • NIL
22
23
Video Instruction: bit.ly/nlrbuild
40
Your Setup is complete.
A:
Align end-cap to
corner of extrusion.
B:
Depress the centre
of the end-cap and align
the tab to the first hole.
Then align second tab
with the second hole.
39
Align the mounting holes on the Tool Kit Holder with the T-Nuts previously installed in
Step 38
.
Bolt through and secure with 2 x M8 Bolts and Nylon Washers.
38
Install 2 x T-Nuts in the front and rear outside channels of one of the Wheel Posts.
C:
Finished End Cap.
YOUR COCKPIT IS COMPLETE
It’s time to install your electronics. If you have any questions about your setup you
can contact us directly at:
or you can join the
community on Discord or Facebook
bit.ly/nlr-discord
bit.ly/NLRowner
37
Loosen the Bolts securing the Mounting Arms to the Wheel Posts. Adjust to the desired position and
tighten the Bolts to secure in place.
Repeat
on Other
Side
WHEEL ASSEMBLY HEIGHT ADJUSTMENT
Note:
Support the Wheel Assembly while
adjusting to prevent it from slipping.
