Nexcom PEAK 760 Series, Руководство пользователя

Страница: 46 / 78

PEAK 760 User’s Manual 45 Appendix A
Precomp Write pre-compensation cylinder
Landing Zone Landing zone
Sector Number of sector
Refer to your drive’s documentation or look on the drive if you need to obtain this information. If no
device is installed, change the value to None.
Drive A
Select this field to the type of floppy disk drive installed in your system. The choices are:
None: No floppy drive installed
360K, 5.25 in: 5-1/4 inch PC type standard drive; 360 kilobyte capacity
1.2M, 5.25 in: 5-1/4 inch AT-type high-density drive; 1.2 megabyte capacity
720K, 3.5 in: 3-1/2 inch double-sided drive; 720 kilobyte capacity
1.44M, 3.5 in: 3-1/2 inch double-sided drive; 1.44 megabyte capacity
2.88M, 3.5 in: 3-1/2 inch double-sided drive; 2.88 megabyte capacity
Note: The None option could be used for diskless workstations.
Video
Set this field to the type of graphics card installed in your system. If you are using a BGA or higher
resolution card, choose the EGA/VGA option. The options are:
EGA/VGA Enhanced Graphics Adapter/Video Graphics Array. For EGA, VGA, SEGA or PGA
monitor adapters
CGA40 Color Graphics Adapter, power up in 40 column mode
CGA80 Color Graphics Adapter, power up in 80 column mode
MONO Monochrome adapter, includes high resolution monochrome adapters
Halt On
During the Power-On Self-Test (POST), the computer stops if the BIOS detect a hardware error. This
setting determines which type of error will cause the system to halt during boot. The options are:
All Error: Whenever the BIOS detects a non-fatal error, the system will be stopped and you will be
prompted.
No Errors: The system boot will not stop for any error that may be detected.
All, But Keyboard: The system boot will not stop for a keyboard error, but it will stop for all others.
After you have made your selections in the Standard CMOS Setup screen, press <ESC> to go back to the
main screen.