Nexcom PEAK 760 Series, Руководство пользователя

Страница: 55 / 78

PEAK 760 User’s Manual 54 Appendix A
4.15 Set Password
The User Password utility sets the password. The main board is shipped with the password disabled. If
you want to change the password, you must first enter the current password, then at the prompt enter your
new password. The password is case sensitive. You can use up to eight alphanumeric characters. Press
<Enter> after entering the password. At the next prompt, confirm the new password by retyping it and
pressing <Enter> again.
To disable the password dialog box appears. A message appears confirming that the password has been
disabled. If you have set supervisor and user Password, only the supervisor password allows you to enter
the BIOS setup program.
Note: If you forget your password, the only way to solve this problem is to discharge the CMOS
memory by turning power off and placing a shunt (jumper cap) on jumper JP2 to short pin 2
and pin 3 for five seconds, then putting the shunt back to pin 1 and pin 2 of JP2.
4.16 Save & Exit Setup
Selecting this option and pressing <Enter> will save the new setting information in the CMOS memory
and continue with the booting process.
4.17 Exit Without Saving
Selecting this option and pressing <Enter> will exit the Setup utility without recording any new values or
changing old ones.