Peak 602VL User's Guide
Rev. B0
Dec. 2000
BIOS Setup
4-29
Supervisor/User Password Setting
You can set either supervisor or user password, or both of then. The differences between are:
supervisor password :
can enter and change the options of the setup menus.
user password
:
just can only enter but do not have the right to change the options of the setup
menus. When you select this function, the following message will appear at the
center of the screen to assist you in creating a password.
ENTER PASSWORD:
ENTER PASSWORD:
ENTER PASSWORD:
ENTER PASSWORD:
Type the password, up to eight characters in length, and press <Enter>. The password typed now will
clear any previously entered password from CMOS memory. You will be asked to confirm the password.
Type the password again and press <Enter>. You may also press <Esc> to abort the selection and not
enter a password.
To disable a password, just press <Enter> when you are prompted to enter the password. A message
will confirm the password will be disabled. Once the password is disabled, the system will boot and you
can enter Setup freely.
PASSWORD DISABLED
PASSWORD DISABLED
PASSWORD DISABLED
PASSWORD DISABLED
When a password has been enabled, you will be prompted to enter it every time you try to enter Setup.
This prevents an unauthorized person from changing any part of your system configuration.
Additionally, when a password is enabled, you can also require the BIOS to request a password every time
your system is rebooted. This would prevent unauthorized use of your computer.
You determine when the password is required within the BIOS Features Setup Menu and its Security
option (see Section 3). If the Security option is set to “System”, the password will be required both at boot
and at entry to Setup. If set to “Setup”, prompting only occurs when trying to enter Setup.
