- Trial fit each part before gluing . Be certain that there are no gaps.
If the parts will join, but with a gaps, sand or trim the parts a little at
a time until the parts meet exactly with no gaps.
- Check for the correct dihedral angle
Before gluing:
- Draw the center line on the wing joiner.
Coat one half of the dihedral brace with epoxy up
to the center line. Install the epoxy-coated side of
the dihedral brace into the wing joiner cavity up to
the center line.
WING TOP-VIEW
A B
A B
30 min. Epoxy
Draw the center line
on the wing joiner
Carefully slide the wing halves together, ensuring that
they are accurately aligned. Firmly press the two halves
together, allowing the excess epoxy to run out.
Note: The two wing halves roots mustfit together perfectly.
Clear off the excess epoxy.
! Make sure to glue securely, If not properly glued,
a failure in flight may occur.
Hold the wing halves together with paper
clamp and rubber band.
Glue must go inside
Wing joiner
Glue
Wing half
IMPORTANT:
Please do not clean off the excess epoxy on the
wing with strong solvent or pure alcohol, only use kerosene to
keep the colour of your model not fade.
Rubber band
(not include)
Paper clamp
(not include)
Nylon wing bolt
(included)
WING TOP-VIEW
A B
A B
30 min. Epoxy
WING TOP-VIEW
4- Joining the wing
