Newton Security T-DAR T1000, Инструкция по установке и эксплуатации

Страница: 38 / 92

38
CONNECTION TO LAPTOP / LAN
To Configure the Host TCP/IP Connection
1. The factory set TCP/IP connection on the host computer is typically set to
“automatic”. Changing these settings will establish a connection to the
Newton Security Inc. TDAR, but may disconnect or even conflict with your
current network system. Please check with your network administrator if you
have any questions.
2. From the desktop right click “My Network Places” and select “Properties”. A
new window will open, select “Local Area Connection” and click “Properties”
from the new selection. A third window will open, select “Internet Protocol”
(TCP-IP) and click its “Properties”.
3. You will see a selection box labeled “Use Following IP Address, select this
option.
4. Enter the following information:
a. IP: 10.0.0.21 (unless the unit is .21, then use .22, etc)
b. Subnet: 255.0.0.0
c. Gateway 10.0.0.1
5. Apply these changes and return to the desktop. You may have to reboot your
host computer before the changes take effect. The system will now connect
using the
Configure Connection option in the User Interface.
Install the Software
The Newton Security Inc. T-DAR System Software CD-ROM contains an installer for
the user interface application and a loader program for the T-DAR Door Control Unit
application.
User Interface (UI) Application
1. Insert the T-DAR Software CD-ROM into the host PC.
2. Press Start on the Task bar and select Run.
3. From the Run dialog box, type d
1
1
:\setup or
4. Browse to the CD-ROM drive and execute setup.exe.
5. Follow the on-screen instructions.