NewTeam 1500-XT, Инструкция по установке и руководство пользователя, Страница: 8 / 16

Fitting the Riser Rail
No Part Description
1 Rail end cap
2
Spirit level
3-4
Rail with slider attached
5 Soap Dish
6
Screw cap
7
Soap dish fixing screw
Rail fixing screws &
wall plugs
Before proceeding with fitting the rail, identify each of the items supplied
using the illustration.
The slider need not be removed from the rail during fitting. The top of
the slider has a smooth profile, whereas the underside has a recess
revealing the grooves on the handset holder.
Fit the soap dish onto the bottom end of the rail and secure using the
small screw from the kit.
Position the rail on the wall, bearing in mind the heights of people likely
to use the shower, and the length of the hose when connected to the
shower and passed through the retaining hole in the soap dish. Mark
the wall to indicate the upper fixing screw position. Screw centres are
605 mm (approx. 23 - inches,) apart.
Drill the wall at the marked fixing position using a 6 mm drill, and loosely
fix the rail end, checking that the rail is hanging vertically using the spirit
level incorporated into the top end of the rail. The bubble should be
exactly between the two lines on the spirit level body. Mark the position for
the lower fixing screw, move the rail to one side, drill the wall, and fix
the lower end of the rail.
Check that the rail is vertical and tighten both fixing screws.
Slide the end cap into position on the top end of the rail, and fit the
screw cover into the recess in the soap dish.
When fitting the hose, it should pass through the larger hole of the soap
dish.
NOTE: The hose nut, and not the handset handle, fits into the slider,
and the slider moves more freely on the rail if gripped next to the rail,
rather than at the handset.
Spirit Rail Kit
Fig 7 - Riser Rail
7
NEWTEAM 1500-XT