NewTeam 1500-XT, Инструкция по установке и руководство пользователя, Страница: 6 / 16

Fitting your Shower
5
NEWTEAM 1500-XT
Water/Electrical Connections
WARNING:
Do not fit fuse or switch on mains electrical supply until all plumbing work is
completed. Connecting pipework can feed from above or below the unit, or straight
through the wall at nominal centres of 40mm.
Top Feed = Hot on the right /cold on the left
Bottom Feed = Hot on the left/cold on the right
Back Feed = Hot on the bottom/cold on the top
Procedure:
• The integral fittings on the valve are of the self-seal push-fit type. All burrs and rough
edges must be removed from the end of the tube. Where chrome plated tube is
used, roughen or remove the first 25mm of plating
• The inlet elbows supplied are of a standard length, in some cases these will
need to be shortened for correct installation.
Fig 3
-
Fixing points - 1500-XT
Collet
Fig 4
-
Push fit fittings.
Cold
Hot
Removal of Front Cover
and Control Knobs
Please note that this product comes packaged with the front cover and control
knobs already in place. These have to be removed to install the shower. Please
follow the procedure below (Fig 5):
1. Pull off control knob (1).
2. To remove the graphic ring (2) which surrounds the main control knob, insert a
thin bladed screwdriver into the recess marked (3). gently prise off the ring,
revealing 2 fixing screws.
3. Remove lower logo (4) by inserting a thin bladed screwdriver in the slot, to
reveal the lower fixing screw.
4. Remove all 3 fixing screws (5). The cover can now be slowly removed - care
should be taken no to strain wiring which is attached to the front cover.
5. This procedure can be reversed to replace the front cover and control knobs
after installation to the wall.
1
2
5
5
5
3
3
3
4
Fig 5
-
Removal of front cover.