New Holland 140TL, Оригинальное руководство пользователя

Страница: 63 / 86

5 - MAINTENANCE
5 - MAINTENANCE ###_7_###
GENERAL INFORMATION
Basic instructions
CAUTION
Unexpected machine movement!
1. Disengage all drives.
2. Engage parking brake.
3. Lower all attachments to the ground, or raise and engage all safety locks.
4. Shut off engine.
5. Remove key from key switch.
6. Switch off battery key, if installed.
7. Wait for all machine movement to stop.
Failure to comply could result in minor or moderate injury.
C0038A
Adequate lubrication and maintenance on a regular schedule is vital to maintaining your equipment. To ensure long
service and efficient operation, follow the lubrication and maintenance schedules outlined in this manual. The use of
proper fuels, oils, grease and filters, as well as keeping the systems clean, will also extend machine and component
life.
NOTICE: Always use genuine NEW HOLLAND replacement parts, oils and filters to ensure proper operation, filtration
of engine and hydraulic systems. See your NEW HOLLAND dealer for additional oil quantities.
General Information
NOTICE: While any company can perform necessary
maintenance or repairs on your equipment, NEW HOL-
LAND strongly recommends that you use only authorized
NEW HOLLAND dealers and products that meet given
specifications. Improperly or incorrectly performed main-
tenance and repair voids the equipment warranty and
may affect service intervals.
Regular lubrication is the best insurance against delays and repairs. Proper lubrication will extend machine life. Refer
to the following charts for lubricants and service intervals.
NOTICE: Failure to complete the required maintenance at the recommended intervals can cause unnecessary down-
time.
The intervals listed are guidelines to be used when operating in normal conditions. Adjust the intervals for operating
in adverse environmental and working conditions. The intervals must be shortened for sandy, dusty and extremely
hot operating conditions.
Check all hardware to ensure that it has been properly installed and tightened. Retighten the hardware after the first
10 hours of operation and every 50 hours thereafter.
Grease Fittings
Wipe dirt from fittings before greasing. Pump fresh grease into fitting to adequately lubricate the component and force
out any contamination from the grease passage. Wipe off excess grease. Use a grease gun containing clean, high
grade multipurpose grease.
5-1