NEW BRUNSWICK SCIENTIFIC BIOFLO III, Руководство по эксплуатации

Страница: 17 / 92

8. Connect drain line to the rear of the cabinet.
9. Connect air line to the rear of the cabinet. Adjust air pressure to 10 PSIG
max.
10. Connect the quick connects of plastic water lines to the vessel base and the
exhaust condenser.
11. As soon as the power switch is turned ON, press the prime switch ON and
hold for approximately 10 seconds or until water runs out the drain line at
the rear of the unit.
IMPORTANT NOTE:
When turning the power switch ON, particularly at initial installation.
It is important that the unit is properly primed by filling the water
circulation loop to prevent the circulating pump from running dry
for any period of time.
12. Check that the machine functions properly.
13. Pull out the pH probe from the pH port and calibrate it (see Section 3.6).
3.4 STERILIZATION PROCEDURE
1. Remove the motor from the top of the vessel and place it on the motor mount
at the top of the cabinet.
2. The housing cover is to be positioned on the top of the bearing housing before
sterilization (Fig. 26).
3. Disconnect air line of the inlet filter side.
4. Disconnect all probes and remove probe cables.
5. Disconnect vessel heater and exhaust condenser water lines.*
6. Remove the sampler rubber bulb then insert glass wool into sampler port and
close sampler valve.
7. Empty and clean the vessel.
8. Fill vessel with medium or sterilized water.**
9. Sterilize the complete assembly consisting of jar, headplate and components
of headplate by inserting in an autoclave.
M1226-0050 10