9
7.3 Water Quality
Tap water may be used in your device,
however, be sure the water is not considered to be “hard”
and
that it contains no impurities or you may clog the system. If your water is hard, you must use softened
water (suggested 3.5 to 8.5 gpg) will damage the waterplace and void the warranty. If a direct
connection is used and you have hard water, it is recommended you install an inline water softener.
Do not connect to a reverse osmosis system or fill with distilled water. The lack of mineral content in the
water will result in a diminished flame effect.
If you are not using the waterplace for more than a week empty the tanks to prevent buildup.
7.4 Using the Device
NetZero Fire Waterplace devices have multiple control possibilities.
1- Manual (On/Off button)
2- Via remote control
The remote control is paired with your device in the factory. However, if you want to change your
remote control, you must install the new one onto your device (device in OFF position). Just press and
hold the ON/OFF button for 5 seconds.
The ON/OFF button will start to blink. Then, simply press any
button on the remote control.
You will hear a confirmation beep, and the remote control will be paired
to the module.
Buttons on your remote control:
On/Off
: Turns the device on or off.
Attention:
The ON/OFF button on the device must be switched on.
Orange On/Off
: The row of orange LEDs can be switched on or off.
RGB On/Off
: Starts or stops the RGB lights. (Only on the Waterplace Platinum Series)
Flame height
:
Increases or decreases the height of the flame. With each change of height, the device
will beep. At the maximum and minimum settings, the device will no longer beep. There are 8 settings
possible.
Flame speed
: Changes the speed of the flames. At the maximum and minimum settings, the device will
no longer beep. There are 8 settings possible.
