13
8 CONNECTING SEVERAL DEVICES TO CREATE A FIRE LINE
Choose one of the devices that will be the MAIN receiver. All the other devices will be secondary and
depend on this MAIN for control. You can choose any of your devices to be the MAIN.
When you receive your devices, they are all mains. Once you choose your MAIN, adjust all the other
modules as follows so they will become secondary units.
Simultaneously hold the On/Off and B2 buttons for 5 seconds. You will hear a short beep and the
device is now secondary.
Note that for fireplaces that have several modules, the smartphone app must be registered ONLY for
the MAIN.
9 DEVICE MAINTENANCE
WARNING: All cleaning and maintenance operations must be done with the device switched off.
Occasionally clean the visible parts with a soft cloth. Never interfere with the safety or electronic
systems - Contact NetZero Fire dealer.
Some components are required to ensure the safety and proper operation of the device. Their
replacement may modify the performance of your device. Only original components should be used for
maintenance or repair operations. This maintenance may only be carried out by authorized specialists. If
these instructions are not followed, our liability will not be incurred. If you plan on moving the device,
always do so with the
reservoir emptied
.
Cleaning and maintenance:
If you do not use your device for more than one week, it is very important
to empty it to prevent stagnant water.
After using for a while, your device may produce less vapor, and as such, reduce the quality of the
flames. You should then clean or replace certain worn-out parts, such as the ultrasonic Mist Maker, the
lifespan of which is between 2,000 and 3,000 hours (depending on the quality of the water used).
Steps for cleaning the mist maker:
•Turn your fireplace off then
unplug the mist maker wire from the power outlet located at each of the
large round mist tube housings.
•Remove mist maker racks from the mist tubes. Depending on the amount of scale present, you can
simply put a few drops of white vinegar directly on the white center of the mist maker and let it set for
a few minutes before rinsing it off and returning the rack to the mist tube.
