Lithium Battery Warning Instruction
There is a risk of explosion if the battery is replaced by a battery of an incorrect type. Dispose of used batteries according to the
instructions.
Electrostatic Discharge (ESD) Precautions
To reduce the risk of equipment damage, the UX system should be kept in an electrostatic discharge (ESD) protected environment. The unit should be
properly grounded at all times. The UX chassis should be plugged in and its grounding lug should be connected. When performing routine maintenance
on the unit, a wrist strap should be plugged into the ESD jack located on the rear of the chassis.
Prevention of ESD Damage
To prevent ESD damage observe the following precautions:
Wear an ESD grounding strap connected to a proper ground when handling modules.
Keep boards in their antistatic protection bags until you are ready to install them.
Do not touch pins, leads, or solder connections on the boards.
Handle modules only by their edges, ejector handles, or stiffener rails.
Store and ship modules in antistatic protection packaging.
ESD Ground Connection
UX Series equipment provide an ESD ground connection in the form of a grounding plug for installation and removal of user-serviceable components. Use
an ESD wrist strap attached to the grounding plug located on the rear of your UX unit.
ESD Ground Connection Wrist Strap
For information about where to plug in the ESD grounding device at the chassis, see
.
UX2000 Hardware Specifications
The ESD wrist strap must be attached to the grounding plug located on the rear of your UX unit. The figure below illustrates the location of the ESD
grounding plug.
