NetPing server room environmental monitoring solutions and IP power distribution units.
Copyright © NetPing east Co., Ltd / E-mail:
/ Phone: +886-2-23121582
[email protected] www.netpingdevice.com
Timer/Counter 1...4
The control of a built-in timer/counter
set from 0 (the timer
function)
Start the timer from 0. The countdown is
carried out in seconds with a resolution of 0 ...
1sec.
reset to 0
Stop and reset the timer. Reset counter.
add 1 (the counter
function)
Add 1 (increment) to the current counter
value.
decrease 1 (th counter
function)
Decrease 1 (decrement) from the current
counter value. The counter value does not
decrease below zero.
IO line 1...4
The control of IO line
off (log.0)
Set the line to log.0 state.
on (log.1)
Set the line to log.1 state.
switch
Switch log. state of the line
impulse
To send an impulse to the line. Duration is set
in the settings of the IO line.
IR 1...4
Send an IR command with a specified number
send a command
Play the command with the specified number
recorded in the memory of the
ule
SNMP Setter 1...2
The sending of SNMP SET commands to the other
devices
off
Record the value corresponding to “off” to the
specified OID in Setter’s settings.
on
Record the value corresponding to “on” to the
specified OID in Setter’s settings.
7.
The buttons are used to change the position of a rule in the list. Starting with DKSF software version 48.5.3, the
The buttons “above” / “below”.
order of the rules does not affect the priority of the rules.
8.
The "
" button saves the programmed logic rules in the device memory.
Apply the changes.
Apply Changes
it is not recommended to mix the functions
of timer and counter.
You should avoid conflicting rules if they can lead to an attempt to control the same output simultaneously .
