NetPing server room environmental monitoring solutions and IP power distribution units.
Copyright © NetPing east Co., Ltd / E-mail:
/ Phone: +886-2-23121582
[email protected] www.netpingdevice.com
1.
2.
3.
4.
5.
6.
[ENG] 11.1. [DKSF 48.5 IU] How Can I Record IR Commands Correctly?
An IR Control module works with an IR transceiver IRC-TR v2. The transceiver can record and reproduce IR signals from remote controls of home
appliances.
To record IR commands, there is a need to go to the page «
» of a device web interface:
IR COMMANDS
New IR commands are recorded in the section «
»:
IR COMMAND RECORDING
Prepare an IR remote, from which it is necessary to capture a command.
Make sure that a red LED on the IR transceiver glows steadily
Choose a command number « » and enter its description into the field «
».
N
Memo (device, command)
Click the button «
». Send a command from an IR remote 30 seconds after clicking the button «
». Otherwise,
Start recording
Start recording
a transceiver will go to a standby mode. A remote and a transceiver must be disposed coaxially at the distance of 10-30 cm for an «eye»
of a transceiver to see a transmitting IR LED of a remote. A command will be recorded.
Check a recorded command by clicking the button «
».
Play/Test
Click the button «
» to save a command in a nonvolatile memory if a command is successfully reproduced.
Save
It is desirable to check again the operation of an IR command by clicking a corresponding button « » in the section of saved commands.
>
