The EXPMT 2000 stores the measured values of each test performed
in memory. At the completion of the automatic test sequence, the
results may be sent to a printer or to a PC through the RS232
interface. The set and measured values are compared. If there is a
deviation of more than 10%, a comment to that effect is printed.
Note:
Test results are saved in the memory during an auto test
sequence until the instrument is switched off. This permits multiple
copies of the
results to be made on the printers and /or PC.
2.9 Printer Functions
In the Level 3 Main Pacer Menu the Pri ‘F3’ key will access various
printer options.
A. Press the Prtr ‘F1’ key to select either the Citizen or Seiko
printer.
Seiko DPU411 type II thermal printer
To print the test measurement results on the Seiko DPU 411
thermal printer, follow these steps:
1 Set the dip switches at the bottom of the printer to the
following:
Dip switch 1: 4, 5, 7, and 8 ON
Dip switch 2: 1 and 2 ON
The remaining switches should be in the OFF
position.
2 Connect the printer cable from the EXPMT 2000 to the
serial input connector (DB-25 connector) of the printer
DPU 411.
3 Turn the printer ON and press the ON LINE switch on the
printer (online LED lights up).
Now the printer is ready to receive data from the EXPMT 2000.
Select PRI in the main menu of the EXPMT 2000 and press the
‘F1’ key. The ‘Select Printer’ menu is now displayed showing the
printer options. Now select F4 (Seiko) key to print the results.
B. Press the PC ‘F2’ key to save the test measurements.
EXPMT 2000 User Manual
23
