b. Using the needle-nose pliers, gently remove the retaining clip from the hinge pin shaft and set
it aside.
c. Slide the hinge pin and spring out of the hinge body.
d. Rotate the hinge so that the thread holes are facing the opposite side of the hinge, and then
install the hinge pin and spring back into the hinge.
e. Install the hinge retaining clip onto the hinge pin.
Make sure that you push the retaining clip completely onto the hinge pin.
4. Reinstall the hinges:
a. Insert the top Allen screw through the system cabinet upright, aligning it with the top threaded
hole on the top hinge, and then partially tighten the Allen screw.
Do not completely tighten the screw until after the second Allen screw is installed.
b. Insert the bottom Allen screw through the system cabinet upright, aligning it with the bottom
threaded hole on the top hinge, and then partially tighten the Allen screw.
c. Tighten the top and bottom Allen screws.
d. Repeat these steps for the bottom hinge.
5. Remove the screws from the lock catch, and then move the lock catch to the opposite front-side
system cabinet upright.
6. Rotate the catch 180 degrees, and then secure it to the system cabinet upright.
Reinstalling the door and illuminated badge
After you move the power supply and components to the other side of the system cabinet and moved
the hinges and lock catch, you must reinstall the system cabinet door and the illuminated badge, and
then reconnect the badge to the power source.
Reinstalling the system cabinet door
After you reverse the door hinge and door catch, you must reinstall the grounding wire and lug
assembly and wire, and the system cabinet front door prior to reinstalling the illuminated badge.
Steps
1. Rotate the door 180 degrees.
2. Align the bottom of the door with the bottom hinge post, and then seat the door bottom on the
hinge post.
3. Lift the top hinge pin so that it clears the hinge housing.
4. Tip the top of the door into the hinge housing so that the hinge pin and door hinge are aligned,
and then release the hinge pin.
Make sure that the hinge pin is seated completely through the door hinge and the bottom of the
door hinge housing.
5. Reattach the grounding lug and wire assembly to the system cabinet frame on the same side of the
newly reversed front door and reinstall the grounding lug with spade on the top of the system
cabinet door.
6. Reattach the grounding wire to the spade on the grounding lug assembly on the system cabinet
door.
Reversing the system cabinet front door | 29
