Removing the system cabinet door
You must remove the system cabinet door and side panels to move the illuminated badge and
components, and to reverse the door.
Steps
1. Open the system cabinet door if it is not already open.
2. Perform the appropriate action depending on whether your cabinets are connected with the
interconnect kit.
If your system cabinet is...
Then...
Not connected to another
system cabinet
Go to the next step.
Connected to another system
cabinet with an interconnect
kit
Remove all four interconnect kit brackets and set the brackets and screws
in a safe place.
3. Unlock both side panels, disconnect the grounding wires from the side panels, and then remove
them and set them aside.
4. Disconnect the grounding wire from the grounding spade located at the top of the door.
5. Unscrew the grounding lug and wire assembly from the system cabinet frame and set it aside.
6. Unscrew the grounding lug assembly from the system cabinet door and set it aside.
7. Lift the top hinge pin until it clears the bottom of the hinge.
8. Gently tip the top of the door away from the system cabinet frame, and then release the hinge pin.
9. Lift the door off the bottom hinge, and set the door aside.
Moving the badge power supply and cabling
You must move the power supply and illuminated badge cabling to the opposite side of the system
cabinet frame before you reverse the door and reinstall the illuminated badge.
Before you begin
You must have removed the system cabinet door and side panels.
About this task
You must move the illuminated badge power supply, power cable, and cabling conduit to the opposite
side of the system cabinet when you reverse the system cabinet door. The assembly is designed so
that the cable to the badge is on the side of the cabinet where the door hinge is installed.
Steps
1. Open the power cable retaining clip, and then disconnect the power cable from the power supply.
2. Remove the power supply housing and power supply, using the illustration for reference:
24 | 42U 1280 mm System Cabinet Guide
