180
o
1
a. Rotate the rubber cable retainer on the cabinet upright 180° to the right, remove it from the
system cabinet frame, and then gently pull the cable out of the system cabinet.
b. Move the cable to the other side of the cabinet, and then thread it completely through the hole
near the top of the cabinet upright.
c. Align the rubber cable retainer with the hole in the frame, push it in as far as it will go, and
then rotate the cable retainer 180° to the left to secure it.
d. Run the cable along the cabinet frame to the back of the cabinet.
6. Reinstall the cable conduit:
a. Slide the conduit over the PDU power cable and route the conduit along the system cabinet
frame to the PDU.
b. Install the conduit retaining clips from the other side of the cabinet over the conduit to secure
it to the cabinet frame.
7. Plug the badge cable back into the power supply, but do not reconnect the power supply to the
power source.
Reversing the door hinge and lock catch
When reversing the system cabinet door, you must move the system cabinet door hinge and lock
catch to the opposite front-side system cabinet upright.
Before you begin
You need the following tools:
•
Phillips screwdriver
Reversing the system cabinet front door | 27
