413 mm
1,257 mm
M8x20 mm
bolts x2
rear
M8x20 mm
bolts x4
front
Secure all 4
brackets to
base with
appropriate
bolts
(not provided)
1
1
2
1
Front and rear bolt-down brackets
2
Location of floor anchor point on the bracket
2. Mark the anchoring points where the rear bolt-down brackets will be anchored to the floor, and
then drill the holes for the brackets.
Be sure to use the appropriate bolt sizes and type for your floor.
3. If the bolt-down brackets are too low to align with the mount points on the system cabinet frame,
place a spacer bracket over the hole in the floor.
4. Loosely bolt the rear brackets to the floor, and then using the kit bolts, bolt the brackets to the
cabinet frame.
5. Mark the anchoring points where the front bolt-down brackets will be anchored to the floor, and
then drill the holes for the brackets.
6. If the bolt-down brackets are too low to align with the mount points on the system cabinet frame,
place a spacer bracket over the hole in the floor.
7. Bolt the front brackets to the floor, and then using the kit bolts, bolt the brackets to the cabinet
frame.
8. Lower the leveling feet as needed, and then tighten the rear bolt-down brackets to the floor.
Installing additional support rails
Your system cabinet has some support rails already installed in it. If you need additional support rails
for your system, you must install them before installing your system components.
About this task
This task applies to all controller and disk shelves except the DS212C and the DE212C disk shelves.
Use the instructions in the rail kit flyer applicable to those two disk shelves.
Installing a DE212C or DS212C Shelf in a Two-Post or Four-Post Rack
16 | 42U 1280 mm System Cabinet Guide
