Door Installation
Fix the door assembly to the fruit cage framework
by opening the hinge fittings and placing over tube,
once you’ve placed the door in the desired position
secure the hinge clamps with the provided nuts and
bolts.
(SEE FIG12)
Open and close the door to check the clearance
of the door on the ground, if necessary
adjust the door by releasing the bolts on the hinge
clamp and sliding the door up or down until correct,
re-tighten the bolts.
Support Bar
Doors can add extra weight to your cage therefore
2 support bars are included with every door kit,
you can position these where desired to add rigidity
the door are of your cage, the diagram
FIG13
shows an
example of how to position them but this will vary
depending on your door position and cage setup.
FIG10
FIG11
Securing door post uprights
The door kit is supplied with 2 qty x hinged
tube clamp connectors. Slot each connector
into the 2 qty x door upright posts
(SEE FIG10).
Clamp each door upright tube onto the horizontal
tube and secure with nut and bolt
(SEE FIG11).
Make sure that the door post is vertical and secure.
Installation
Guide
1065mm
FIG12
FIG13
