Ness R8
- Installation and Programming Manual
47
DIALLER OPERATION
DIALLING SEQUENCE
The dialler follows the re-dial procedure shown until the message is successfully reported. The
dialler cycles around the Panel telephone numbers, skipping numbers not programmed. If P70E
or P71E are programmed, then the Voice Dialling numbers, P00E and P01E are ignored.
A successful report is defined as a report which has been “kissed-off” by the Central Station or by
a hash (#) tone in the case of Audible Format dialling to a private number.
1. Dial Central Station Ph No. 1, (P70E) and report alarms in Contact ID format. ...If not kissed
off...
2. Dial Central Station Ph No. 2, (P71E) and report alarms in Contact ID format.
3. If P70E and P71E are blank, dial Voice Dialling Ph No. 1, (P00E) and report alarms in Ness
Voice Dialling format. ...If not kissed off...
4. If P70E and P71E are blank, dial Voice Dialling Ph No. 2, (P01E) and report alarms in Ness
Voice Dialling format.
4. Accumulate maximum of 15 failed attempts.
5. Attempt to dial unsuccessful numbers a second time after 30 seconds, a total of 10
attempts.
6. Wait 5 minutes then subsequent attempts are 1 hour apart.
7. A maximum of 15 dial attempts for the same event
8. New events re-start the sequence at 1.
No more than 20 dial events will be reported between each disarming of the panel.
MESSAGE QUEUE
The panel places event reports in a queue. Multiple simultaneous reports or reports previously
unsuccessfully dialled will be included in the current call.
The oldest report on the queue is sent first. If the queue is full (8 messages), a new report will
overwrite the oldest report.
THE CURRENT DIALLER QUEUE IS CANCELLED AND THE DIALLER BUFFER IS ERASED
ON ENTRY TO INSTALLER PROGRAM MODE.
NESS VOICE DIALLING
The dialler sends alarm reports to a private telephone, (mobile
telephone or fixed telephone), using Voice Dialling Telephone
numbers 1 and 2, (P00E, P01E). See page 20.
If P00E or P01E are programmed with a telephone phone number,
then alarms will be sent to that phone number/s in Ness Voice
Dialling format.
The word 'ALARM' is repeated until the # DTMF key on the
telephone is pressed or 30 seconds expires. If the # key is not
pressed, the number will be redialled.
The person receiving the call can then acknowledge, (“kiss-off”),
the alarm by pressing the
key on their telephone.
MONITORED
PREMISES
AUDIBLE MONITORING
TELEPHONE LINE
ANY TELEPHONE
Voice Dialling format is
disabled if a Central
Station telephone
number is programmed
at P70E or P71E.
