Ness R8
- Installation and Programming Manual
16
QUICK START PANEL PROGRAMMING
The Ness R8 is supplied pre-programmed with factory default values that should
suit most installations.
The steps below will show you how to program the Master Code (User Code 1),
and the Client Code and telephone number for central station monitoring.
➊
To enter Installer Program Mode.
To enter Installer Program Mode on initial power up, apply power with the internal tamper open, (lid
open), or the external tamper open. Or if you have powered up with all tampers sealed, see below.
PROGRAM
PROGRAM
123 is the factory default
Master Code.
000000 (six zeros) is the factory default
Installer Code.
This is User Program
Mode. The PROGRAM
icon is on steady.
This is Installer Program
Mode. The PROGRAM
icon is flashing.
Press
...then press
1
0
0
2
0
0
3
0
0
➋
To program the Master Code.
Example, to program the Master Code to be 1234.
P11E is the option for
the Master Code.
Press
Enter the new Master Code
followed by E.
Enter the new Master Code again
followed by E.
➌
To program the dialler Client Account Number.
Example Client Code is 9876.
P72E is the option for
the Client Code.
Press
Enter the new Client Account
Number followed by E.
➍
To program the central station telephone number.
Example telephone number is 1234 7890.
P70E is the option for
Telephone Number 1.
Press
Enter the new telephone number followed by E.
➎
To exit Installer Program Mode.
The PROGRAM icon will turn off.
THE PANEL IS NOW PROGRAMMED AS FOLLOWS:
Master Code:
1234
, Dialler Client Account Number:
9876
, Central Station Telephone
number 1:
1234 7890
.
Zone 1:
Delay
, Zone 2:
Handover
, Zones 3–8:
Instant
, Entry Delay Time:
20 seconds
,
Exit Delay Time:
60 seconds
, Siren Reset Time:
5 minutes
.
The client code and telephone numbers are supplied by the central station.
