NESS D8X / D16X DELUXE CONTROL PANEL – USER'S MANUAL
26
REMOTE OPERATION
TELEPHONE REMOTE CONTROL
for V8.0 and later
Remote operation allows:
1. Control of Arming/Disarming, AUX 1 to AUX 8
and Zone Excludes.
2. Voice updates on Arming state, Zone alarm
and excluded state, warning states.
Prompts would be issued when one of these
is changed.
OPERATION
Example:
When the user calls the panel using the accepted
methods and after the panel stops sending the
answer tone sequence.
The user first presses key 3 and the panel starts
the voice prompt:
This is your SECURITY SYSTEM.
To control the security system press STAR, then
enter your USER code, then press HASH.
If the user does this correctly then the voice
prompt continues:
To arm or disarm the system press 1. To
control OUTPUTS press 2. To exclude or include
hang up press STAR then PRESS HASH.
The user presses 1 to arm or disarm the system
and the voice prompt continues:
To arm, Press 1. To disarm, Press 2. To return,
Press STAR.
The user presses 1 to arm and the voice prompt
continues with either of these messages:
TO CONNECT TO THE PANEL BY
TELEPHONE
METHOD 1. The connection is initiated by the
panel during an alarm message.
METHOD 2. The connection is initiated by the
user phoning the panel.
HOW TO INITIATE TELEPHONE REMOTE
CONTROL
1. Phone the panel telephone number and listen
for the required number of rings (the normal
double ring is counted as one ring) and then
hang up.
2. Wait 10 seconds and then call the number
again within 50 seconds.
3. The panel will answer the second call
immediately and respond with an audible
tone similar to a fax tone.
4. Press the
button on your telephone to
start the session.
5. Listen to the voice prompts for instructions.
6. When you're done, press
to hang up.
www.msealarms.com.au
