NESS D8X / D16X DELUXE CONTROL PANEL – USER'S MANUAL
19
OPERATION
AUTO-TIME OPERATION
WARNING PERIOD
(Optional function - must be enabled by your installer.)
When an AutoTime event is about to begin, your keypad (or keypads) will begin a constant
slow beep as a warning that the automatic event is about to happen. The warning beeps can be
programmed to start up to 99 minutes prior to the AutoTime event.
Press any key on the keypad to stop the beeps during the warning period. The beeps will start again
for the final minute at a faster rate.
FINAL MINUTE BEEPS. In the last minute prior to the AutoTime event, the keypad will beep at a
faster rate to warn that the event is about to start.
TO DELAY THE AUTOTIME EVENT
(Optional function - must be enabled by your installer.)
To delay the AutoTime event, enter a valid user code on its own. (The user code must be assigned
to an Area to work). This will suspend the warning beeps and the AutoTime event for 1 hour - when
the warning process will start again.
Example: Your panel is programmed to Auto Arm at 6pm every weekday and the Warning Period is
programmed for 5 minutes. You are working back late and at 5:55pm your keypad begins to beep.
Since you're not ready to arm the system yet, enter your user code (without pressing E) at the keypad.
The warning beeps will stop and arming will be delayed by one hour. At 6:55pm the warning beeps
will start again, followed by automatic arming if you don't delay the event again.
Any AutoTime event can be postponed, not just arming. You can also delay the automatic turn (or
off) of one of the AUX outputs in the same manner.
MANUAL OPERATION OF THE AUX OUTPUTS
(Optional function - must be enabled by your
installer.)
As well as automatic operation by Auto Time, the four auxiliary outputs can also be operated
manually by keypad. Use the keypad commands below to turn outputs on or off or pulse on
1
.
AUX5, 6, 7 & 8 operate as described above. ie, Press 55*, 66* etc
Manual operation of outputs works in conjunction with AutoTime schedules, if programmed. For
example, if AutoTime has turned an output on as scheduled (say, a light) you can manually turn it
off (and back on again) any time you wish. At the scheduled turn OFF time, if the output is still on
it will be turned off.
1
Whether an output "Pulses" or "Turns On" depends on the how that output has been
programmed by your installer.
To turn
ON
or
PULSE
To turn
OFF
AUX1
AUX2
AUX3
AUX4
www.msealarms.com.au
