Neopost IM-75, Руководство пользователя

Страница: 12 / 24

11
ENGLIS
H
4.3 Adjust working height
(optional)
In case of an LO-3 with the
optional height adjustment:
- beware of the heavy weight of the
LO-3 (170 kg) in case of using the
height adjustment.
- height adjustment run/rest time:
1 min. / 20 min.
If the height adjustment is installed the
working height can be adjusted between
720 mm (28.3 inch) and 915 mm
(36.0 inch). The control buttons are
shown in the figure below.
4.4 Operating modes
The system can process in the following
two modes:
• Opto-electronic mode. After starting the
machine the cycle stops when the first
envelope is opened and has reached the
“extraction”. The cycle continues when
the sensor detects the removing of the
document from the envelope.
• Automatic mode. After starting the
machine, the cycle continues until the
operator stops the machine. Envelopes
are opened and transported to the exit
or to an optional conveyor via the
optional transfer station (depending on
the system configuration).
4.4.1 Opto-electronic mode
• Switch on the system: pump and
motors start up. The transport fingers
move into position. The bottom line of
the display shows the counter total.
• Press button C (refer to operating
controls, control panel) for opto-
electronic mode: the envelopes are
transported to the removal station. In
addition to the counter total, the word
“Opto” appears on the top line of the
display with the last delay interval
programmed e.g. “Opto2”.
• The next cycle begins when the sensor
detects the removing of the documents
from the envelope.
4.4.2 Automatic mode
• Switch on the system: pump and
motors start up. The transport fingers
move into position. The bottom line of
the display shows the counter total.
• Press button D (refer to operating
controls, control panel) for automatic
mode. The envelopes are transported
into position up to the removal station.
In addition to the counter total, the
word “Auto” appears on the top line of
the display with the last delay interval
programmed, e.g. “Auto2”.
• Cycles in automatic mode are triggered
by the sensor and interrupted by
pressing the standby switch H.
ca
5
m
m