Neomatica ADM007, Руководство по эксплуатации

Страница: 20 / 26

OOO Neomatica. Terminal ADM007 GLONASS / GPS. Rev.1.3 dated 13.09.2019
20
20
INSTATIC X,Y
Example:
INSTATIC 1,0
INSTATIC X,Y
Example:
INSTATIC 1,0
X=0
– input number,
Y=0, 1
– inclusion by zero
or one.
X=255
–disabled function;
Set the input number to enable the fixation mode. A
command without parameters returns the current
setting. By default, no one input is set to enable the
fixation mode.
21
SPEEDSTATIC X
Example:
SPEEDSTATIC 2
SPEEDSTATIC X
Example:
SPEEDSTATIC 2
X
– the speed below
which the fixation of
coordinates takes place.
X=255
– disabled function
Set the speed which reducing will initiate coordinates
freezing.
22 RESET
reset…
Command without
parameters.
Reboot the device.
23
UPDATE Command without
parameters.
Firmware upgrade.
8 Upgrading tracker software
The tracker software (firmware) can be updated via the Bluetooth radio channel using a
configurator program or via a GPRS channel.
8.1 Updating the tracker software via the configurator
The configurator program, if the computer has access to the Internet, checks the current
firmware version on the update server, and, if necessary, downloads the firmware file.
To update the firmware, do the following:
1. establish connection between the ADM007 tracker and the ADM Configurator program using
the procedure described in 5.1 "Connecting to the Configurator";
2. if ADM Configurator detects the firmware that is more updated than the one installed in the
tracker then it will inform about this - the notification will be displayed in the lower left corner;
3. click "Update available";
4. In the opened "Notifications" tab, click "Update";
5. after the update, the tracker will reboot and become available for configuration.
ATTENTION! Do not switch off the tracker during the firmware upgrade process until the tracker is
detected by the setup program. Otherwise, it is possible to damage the software, which must be
restored in the service center of the manufacturer
8.2 Updating the tracker software via the configurator using the firmware
file
The firmware file must be requested from the technical support.
To update the firmware via Bluetooth using the firmware file, do the following:
1. establish a connection between the ADM007 tracker and the ADM Configurator program using