Neomatica ADM007, Руководство по эксплуатации

Страница: 11 / 26

OOO Neomatica. Terminal ADM007 GLONASS / GPS. Rev.1.3 dated 13.09.2019
11
tracker can save up to 4 numbers. Resetting settings to the factory ones clears the list of phone
numbers.
•
Sending commands from the server via TCP connection
To configure via GPRS, authorization is not required. The tracker receives commands from the
server via TCP connection used for data transmission.
5.3 Setting the connection to the server
Configure the APN settings for the selected cellular operators using the
«SETGPRS0»
command.
Configure the IP address and port of the server (host) using the command
«
SETHOST0
» or
" DN0 ".
Change of these parameters is possible in the graphical interface of the program "ADM
Configurator".
5.4 Setting data transmission
Navigation data and data received from different sensors being transmitted from the tracker to
the server, are divided by data packets. Depending on the functionality used, it is necessary to
activate the transmission of the necessary data packets.
The setting is done in the graphic interface of the ADM Configurator or by PROTOCOL
command.
Table 1 shows the correspondence of data packets to the values of PROTOCOL command. If
data transmission is required to be transmitted from several packets then calculate PROTOCOL
command parameter by addition. To save the traffic it is recommended to set only the transmission
of necessary data packets.
For example:
Main data (0) +analogue inputs (8) = PROTOCOL 8
Table 1. Values of the main parameters for PROTOCOL command
Data packet name Parameter value
Main data NAVIGATION DATA 0
Analogue inputs IN_A 8