Neomatica ADM007, Руководство по эксплуатации

Страница: 10 / 26

OOO Neomatica. Terminal ADM007 GLONASS / GPS. Rev.1.3 dated 13.09.2019
10
Figure 6 - ADM Configurator: the "disable device" button
5.2 Setting using commands
The tracker is managed by commands sent via SMS, GPRS or Bluetooth. The syntax is the
same for any way of sending.
General rules for writing and sending commands:
⎯
only Latin characters and punctuation may be used in commands;
⎯
character case does not matter;
⎯
commands transmission syntax is the same for SMS, GPRS and Bluetooth.
⎯
All commands syntax: «CMD X1,…,X3», where CMD is a command, X1..X3 are commands
parameters.
⎯
Commands are separated by a SPACE. Parameters are separated by commas, except for
the DN0 command which parameters are separated by a colon.
After receiving a command, the tracker executes it and sends a feedback message.
If the command parameters extend beyond the acceptable range, the tracker changes them to
the nearest acceptable values. If it is not possible to change parameters or parameters are not
enough, the tracker will answer with an error message. A command without parameters returns the
current settings.
•
Sending commands using ADM Configurator program
To configure the tracker via Bluetooth, you should use the "ADM Configurator" program. If a
password different from “0” was set in the tracker then the Configurator will ask to enter the
password.
•
Sending commands using SMS messages
To manage the tracker using SMS, it is necessary to send the SMS command " ADD ME 0 " to
the number of the SIM card installed in the tracker, where 0 (zero) is the default password (if the
password has been changed, you should enter it instead of 0). The phone number from which this
command was sent will be authorized in the tracker. An authorization is done only once, afterwards
the tracker saves the telephone number in a non- volatile memory within its whole service life. The