INSTALLATION
STRONG trim PRO
4-6
NEOLT
Adjustment 4.4
The trimmer should not need any specific adjustments, but we do suggest to check the two options
that could be slightly different, due to the final positioning of the trimmer.
Planarity
The first adjustment is the planarity of the working table, which could vary due to unleveled floors.
Follow this procedure to adjust the planarity of the feeding table:
•
Position the profile of rigid material on the trimmer’s table with a well-trimmed side.
•
Check the parallelism between the table and the profile of the rigid material by using the
push rod in the center of the traverse on the upper table
13
. Screw on to lower table,
unscrew to lift table.
•
Furthermore adjust the two supports placed under the table
14
, by putting the screws on
or off. After reaching the desired adjustment block the screw with the two locking nuts.
Sheet holder adjustment
The second operation is the adjustment of the height of the Plexiglas sheet holder when the
carriage is at the far right or left to remove the trimmed media. Follow this procedure:
•
Put the setscrew wrench in the hole of the
transparent sheet holder lifter slide
15
and screw
on to decrease height, unscrew to increase
height.
13
14
15
Содержание STRONG trim pro 130
