Nemtek FG7B, Руководство по установке

Страница: 18 / 19

18
FG7B CONTROLLER Document Revision History
THIRD PARTY INTEGRATION
The FG7 can communicate with third party software such as Nemtek Druid FenceProbe. The
communication is done through the Ethernet port on the blue control board of the FG7.
The IP of the computer running the software should be in the same range as the IP of the FG7
(the IP of the FG7 can be changed under the Net tab).
Once connected the third party software will take control of the system, however the FG7 can
still issue commands and the third party will see the change in the system and can accept it or
override it by reversing the command of the FG7.
If there are IO cards in the system then the mapping of the third party software is followed. It is
however advisable to load the identical mapping into the FG7 so that if the communication to the
software is lost the commands from inputs and the relay outputs on the IO card(s) will remain
identical to the mapping in the third party software, the system would not change due to the
communication break.
If the AbsoluteIO option has been ticked under the system tab the third party software would still
have control but if the communication to the FG7 fails then control would be given to the
mapping of the inputs of the IO card(s) and not to the FG7 User (see AbsoluteIO)
DOCUMENT REVISION HISTORY
Revision 1.0
10 Feb 2017
Revision 1.1
8 March 2017
Added IP addressing and screen calibration
Revision 1.2
9 May 2017
Mapping and procedures added
Revision 1.3
20 July 2017
Added Sync fail, Extended Comms timeout, Alarm sensor mode and proxy options
Changed IO mapping Global and specific on different IO cards.
Revision 1.4
12 September 2017
Changes to allow for an 8 input and 8 output relay card
Revision 1.5
21 February 2018
Changed Extended Comms timeout to Nemlink, added AbsoluteIO, removed picture of 5 relay IO
board, inserted picture of 8 relay IO board, added third party integration
Revision 1.6
6 June 2018
Added Web interface, placed defaulting under user tab, added failsafe