5-16
www.nemalux.com | [email protected] | Tel 403•242•7475 | Fax 403•243•6190
MADE IN CANADA
TM
Nemalux
I N D U S T R I A L
AR Series
rev. A-30
AR-PM – POLE MOUNT INSTALLATION1 (Ordered Separately)
Refer to alternate instructions if using Conduit, Hook, Wall, Yoke Mount, or High Vibration Yoke
INSTALLATION STEPS
Step 3
Step 5
STEP 1.
Inspect shipping package and contents to ensure no
damage has occurred during shipping. Discard
surface/ceiling mounting bracket provided with AR
luminaire. Remove 4 x M6 bolts from supply side of luminaire
and disard.
STEP 2.
Install the provided plastic 3/4” bushing into side 3/4" NPT
entry.
STEP 3.
Install Pole Mount and gasket with adhesive side applied to
mount using included M6 bolts and washers.
Torque to 5 Nm (45 in-lbs)
STEP 4.
Thread luminaire assembly onto 1-1/2” NPT pole.
NOTE:
To aid in assembly and protection against ingress use of a
petrolatum or soap thickened mineral oil based thread
lubricant/sealant is necessary.
Un-used conduit opening must be plugged to maintain the
integrity of the enclosure.
STEP 5.
Insert and tension M6 set screw to pole to lock rotation.
STEP 6.
Resume installation instructions provided with luminaire.
(STEP 4 in AR Installation Instructions provided with
Luminaire)
SET SCREW
This AR-PM kit is intended for use with UL Listed AR luminaire as
marked on the luminaire nameplate.
Accessory Package Contents
AR-PM
PART NAME
QTY
1
1
4
4
1
1
POLE MOUNT
POLE MOUNT GASKET
M6 X 25mm HEX HEAD CAP SCREW
M6 FLAT WASHER
M6 X 16mm HEX HEAD CAP SCREW
3/4 NPT THREADED SMOOTH BORE BUSHING
1-1/2" NPT Entry
WARNING:
The AR Head must not face
upwards by any degree
beyond the vertical position
for Class II, Division 2,
Zone 22, and Class III
hazardous locations.
LIGHT BEAM
HORIZON
ATTENTION:
Le luminaire (AR) ne doit pas
être orientée vers le haut de
quelque degré que ce soit
au-delà de la position verticale
pour les emplacements
dangereux de Classe II,
Division 2, Zone 22 et Classe III
